I just finished a garage rebuild to the engine and at start up the oil pressure only goes to 40 psi and within 5 min it drops to around 8 psi this was the same 2 days in a row with factory gauge and actual oil pressure gauge. Now the pressure is definitely too low but it's the drop that is even more unusual because that's not enough time for the oil to heat up and break down lowing the pressure. I dont believe it's a bearing loss of pressure because even then it would need heat to lower the pressure ( just a theory) but if that's the case where should I be looking when I tear back into it. Anybody run into anything like this before
caroline6.0
Here are a few to choose from but make sure you get the one with the correct threads and diameter / size.
Amazon.com: GlowShift Oil Filter Sandwich Plate Thread Adapter - 3/4-16 Thread - Install up to (4) 1/8-27 NPT Oil Pressure & Temperature Sensors - Includes O-Ring & Port Plugs: Automotive
Buy GlowShift Oil Filter Sandwich Plate Thread Adapter - 3/4-16 Thread - Install up to (4) 1/8-27 NPT Oil Pressure & Temperature Sensors - Includes O-Ring & Port Plugs: Replacement Parts - Amazon.com âś“ FREE DELIVERY possible on eligible purchases
www.amazon.com
Amazon.com: GEARWRENCH Oil Pressure Check Kit - 3289: Home Improvement
Buy GEARWRENCH Oil Pressure Check Kit - 3289: Oil Pressure Tools - Amazon.com âś“ FREE DELIVERY possible on eligible purchases
www.amazon.com
Amazon.com: OTC Tools 7219 Oil Pressure Adapter: Automotive
Buy OTC Tools 7219 Oil Pressure Adapter: Fittings - Amazon.com âś“ FREE DELIVERY possible on eligible purchases
www.amazon.com
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
