Chevy Trailblazer SS Forum banner
1 - 10 of 10 Posts

· Premium Member
Trailblazer SS
Joined
·
28,997 Posts
Discussion Starter · #1 ·
Just finished a regular trailblazer (07 model) and just wanted to post this info up. Many people say the tbss is lowered 2 inches from the factory over the stock trailblazer which is not the case.

With 235 75 16 the stock measurement from ground to fenderlip on a regular trailblazer is 32 7/8 to 33 inches while rear is 34 1/4 to 34 1.2

On a tbss with 255 50 20 stock his 32.5 to 32 3/4 front and rear 33 to 33.5.

So just for you guys to know the front tbss spring drops us only 1/2 a inch and rear the air bags they just set lower which is about 1 inch.

btw with the djm 2/4 drop the regular trailblazer sits at 30 7/8 front and rear 31
 

· Registered
Joined
·
382 Posts
I just finished lowering the rear of my SS to 31 1/4 I'm planning to install my Belltech's on Monday. Is this too low for an AWD SS, using the belltech 1" drop?:confused1:
I left both bolts in the sencor and cut the bump stops down by 1.5". I used a level to make sure both sides were exact as well as a tape meashure, it was easy but did take some time.

Here are some pictures:




 

· Registered
2007 Trailblazer SS
Joined
·
31 Posts
Hey NORCAL, whats the limit of lowering an 07 SS AWD ? I don't want any drivetrain warranty issues but 2" inches looks nice......What parts should I use for the best handling? Your Supercharger must give you a good Rush. Makes me wish I didn't get the 6 year warranty.
THANKS
 

· Premium Member
Trailblazer SS
Joined
·
28,997 Posts
Discussion Starter · #9 ·
Has anybody tried the McGaughey's front lowering kit?
Thanks.

Yes ive done 3 installs and they are by far the WORST RIDING springs i have installed.


belltechs ride the best out of the top three which is belltech eibach or Mgnastys
 

· Registered
2007 TBSS Black. 3SS
Joined
·
41 Posts
Just installed my Bells 1 week ago and I could be wrong but I think they ride better than Stock.. But I wish they were just a bit lower.. May need to change out and go to the DJM Kit that Norcal has set up for us all!! :biggrin2:

Just gotta get that Damn rear sensors to work right!!
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top