Chevy Trailblazer SS Forum banner

1 - 6 of 6 Posts

·
Premium Member
Joined
·
1,304 Posts
Discussion Starter #1
i justgot my beltechs in today and i was going to put them on this afternoon. i want it to sit down a little lower than the 1" drop. i was thinking about cutting 1/2-1 coil off of the springs. how much would this affect the spring rate and ride?
 

·
Administrator
Trailblazer SS
Joined
·
30,401 Posts
ive cut 3/4 loop. There comes a point if you cut to much spring will float. Its not a hard install at all and maybe just throw them in let them settle then come back and cut if you want to.
 

·
Premium Member
Joined
·
1,304 Posts
Discussion Starter #3
well i know im going to want it lower than its going to be without cutting it. with the 3/4 cut out was it ok? how much lower did it drop it?
 

·
Registered
Joined
·
282 Posts
Like Norcal said before I cut them I would put them in and let them settle before I cut them. That way you can know were your ride height will be before you cut them.
 

·
Registered
Joined
·
121 Posts
how low you looking to go


heck do what i did and buy some collars and then cut 1/4" off them to drop it some more
 
1 - 6 of 6 Posts
Top