Chevy Trailblazer SS Forum banner

1 - 20 of 90 Posts

·
Registered
TrailblazerSS
Joined
·
917 Posts
Discussion Starter #1 (Edited)
Update 03.22.20

5 shafts has been made.
They will be drop shipped from MW.

$851 shipped



Hello,

I have been trying to figure out something else than the turned down 27-spline shaft to connect 4L80E to our transfer case for years. I just don`t like that option, period. And I wanted to keep the original transfer with 4L80E.

Now I have been working with Mark Williams Enterprises (Mark Williams Enterprises- Home Page) to get new 32-spline Transfer case input shaft done.
It is ready and available now.

It is made from 4340 steel and heat treated in house by Mark Williams.
You can`t use the original seal because of bigger bore, so custom seal is required and included. Original pilot bearing will fit.

PM for purchase info.


120 shaft outside.jpg

120 shaft inside.jpg

Thanks,


Pete
 

·
Generally insane
2006 TrailblazerSS
Joined
·
70 Posts
I'm facebook jumping trying to get people on board with this. I'd commit to buying 2, have another guy that may also.

Sent from my 831C using Tapatalk
 

·
Premium Member
TrailblazerSS
Joined
·
1,481 Posts
I put a link to this on a Facebook page as well. The smallest amount of people that we have to have is 5, but the price is significantly higher. Hopefully we can get the 10 he needs and get these made!
 

·
Too fast to be so slow.
TrailblazerSS
Joined
·
3,356 Posts
I want one. Please give more details on the shaping and cutting needed though. I would want it done proper so to not need to use RTV. This will have to hold a lot of power...
 
1 - 20 of 90 Posts
Top